LED WATERPROOF BATTENS HWD

EMERGENCY LIGHT

Features

  • Replaceable LED module
  • LED drivers included
  • Available in single and double lamp versions
  • Ingress protection rating: IP65
  • Batteries with 2 or 3 hours options

Electrical Characteristics

Rated supply voltage 220-240 VAC ±10%
Lamp switching cycles >200,000
Ambient temperature (ta) -20 … +50°C
Driver efficiency up to 90%
Power factor ≥95%
THD <15%
CRI >80
Lumen maintenance (L70) >35K Hrs

LED Modules

Using LED modules has more advantages over LED tubes.

  • LED modules are mounted directly on metal plates. This provides better heat dissipation and lower LED junction temperature
  • Higher efficiency due to removal of LED tube diffuser
  • No blocking for human motion sensor.

LED Drivers

The driver is AC and DC LED drivers built into one single unit.

With the internal micro-processor, the whole system is software controlled. These include battery charging, discharge discharging, system changeover, fault protections, LED indications and infrared remote control.

The improves system reliability and makes the system smarter for the whole operations.

The drivers also have buit-in active power factor correction with very low harmonic distortion. Protections with over-current, short-ciruict and open-circuit are provided with automatic restart for ease of use.

Five steps dimming is provided via the infrared remote controller.

green-led-on-off Battery Charging
green-led-on-on Battery Full
red-led-on-on Battery Discharging
red-led-on-off System Errors

LED Indications

The infrared remote control makes battery change-over testing is easier with just a press on the controller. It also provide 5-steps of dimming control for normal AC operation.

Remote Control

The infra-red remote control makes battery change-over testing is easier with just a press on the controller. It also provide 5-steps of dimming control for normal AC operation.

Dimensions

Compliances

EN 61347-2-1 Lamp controlgear. Particular requirements for starting devices (other than glow starters)

EN 61347-2-13 Lamp controlgear. Particular requirements for d.c. or a.c. supplied electronic controlgear for LED modules

EN 62384 DC or AC supplied electronic control gear for LED modules. Performance requirements

EN 60598-1 Luminaires. General requirements and tests

EN 60598-2-22 Luminaires. Particular requirements. Luminaires for emergency lighting

EN 55015 Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment

EN 61000-3-2 Electromagnetic compatibility (EMC). Limits. Limits for harmonic current emissions (equipment input current ≤ 16 A per phase)

EN 61000-3-3 Electromagnetic compatibility (EMC). Limits. Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current ≤ 16 A per phase and not subject to conditional connection

EN 61547 Equipment for general lighting purposes. EMC immunity requirements

FSD Circular Letter No. 1/2006: PPA-104(A) 4th Rev Fire Safety Standards for Emergency Lighting

Ordering Information

Model Lamp
Count
Length
(mm)
HWD-12# 1 660
HWD-14# 1 1276
HWD-15# 1 1576
HWD-22# 2 1320
HWD-24# 2 2552
HWD-25# 2 3144

※ Replace “#” with “E2” or “E3”  for 2-hr or 3-hr emergency lighting option
※ Add suffix “F” for optional fused terminal blocks